Contex SD One MF 44 User Manual page 58

Maintenance
Replacing the glass plate
8
Install the new glass plate in the scanner
1. Pick up the new glass plate with two hands holding it at each end to avoid touching
the glass surface.
Take special care to avoid touching the glass plate's bottom surface which normally
2.
will not be cleaned during maintenance.
3. Stand at the rear of the scanner as you hold the glass.
4. Make sure you hold the glass for insertion with the surfaces facing correctly. Note the
direction of the facetted edges that indicate which is the document side of the glass.
See the glass plate profile illustration (right.).
5. Hold the glass so that it faces as shown below.
6. Lower the glass plate into the scanner at an angle as shown so that the glass plate
lower edge rest in the lower latches (see next step).
CAUTION: The glass plate is long and thin and thus fragile. Take care not to break it.
Glass Plate Profile View:
As you lower the glass plate into the scanner, hold it
at an angle similar to that shown in the illustration.
Sensor side
Document side
Load this end into the
lower latches
Top surface
58