Mounting The Sw Hdmi; Tabletop Use; Rack Mounting - Extron electronics SW4 User Manual

Sw hdmi series two and four input hdmi switchers
Hide thumbs Also See for SW4:
Table of Contents

Advertisement

Mounting the SW HDMI

The SW HDMI switcher can be set on a table, mounted on a rack shelf, or mounted under
a desk, podium, or table.

Tabletop Use

Four self-adhesive rubber feet are included with the SW HDMI. For tabletop use, attach
one foot at each corner on the bottom of the unit, and place the switcher where desired.

Rack Mounting

UL rack mounting guidelines
The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of
the equipment in a rack.
1.
2.
3.
4.
5.
Rack mounting procedures
See the
numbers.
Mounting on a rack shelf
1.
2.
3.
4.
Elevated operating ambient temperature — If the equipment is installed in a
closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore, install the
equipment in an environment compatible with the maximum ambient temperature
(Tma = +122 °F, +50 °C) specified by Extron.
Reduced air flow — Install the equipment in a rack so that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical loading — When mounting the equipment in the rack, ensure that
uneven mechanical loading does not cause a hazardous condition.
Circuit overloading — When connecting the equipment to the supply circuit,
consider the effect that circuit overloading might have on overcurrent protection and
supply wiring. Consider equipment nameplate ratings when addressing this concern.
Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to supply connections other than direct
connections to the branch circuit (for example, use of power strips).
Accessories table
on page 30 for the available rack shelf kits and their part
If feet were previously attached to the bottom of the unit, remove them.
Mount the switcher on the rack shelf, using two 4-40 x 3/16 inch screws in opposite
(diagonal) corners to secure the unit to the shelf (see
Install blank panels or other units on the rack shelf as desired.
Install the shelf in the rack.
figure 23
on the next page).
SW HDMI Series • Reference Information
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw2

Table of Contents