Rear Panel Features - Extron electronics SW4 User Manual

Rear Panel Features

POWER POWER
12V 12V
0.3A MAX 0.3A MAX
1
Figure 2.
POWER
12V
0.3A MAX
1
Figure 3.
a
b
c
INPUTS
1 2
2
SW2 HDMI Rear Panel
INPUTS
1 2
2
SW4 HDMI Rear Panel
Power connector — Plug the provided external 12 VDC, 1 A power supply into this
2-pole, 3.5 mm captive screw connector.
Video input connectors — Connect HDMI video input sources to these Type A
female single-link HDMI connectors. Data rates of up to 6.75 Gbps are supported.
LockIt security brackets: LockIt
•
and the output connector, are provided with the SW HDMI. These brackets can
be used to secure the HDMI cables to the rear panel connectors, reducing stress
on the connectors and preventing signal loss due to loose cable connections. For
information on attaching the LockIt brackets, see the LockIt HDMI Lacing Bracket
Installation Guide card, available on the Extron website at www.extron.com.
EDID information: By default, EDID is read from the output device and written
•
to memory on each input, allowing the source to see the EDID information for the
output device even when the output is switched away from it.
NOTE: If power is recycled to the display, or if a new display is connected, the
source may need to be rebooted to read the new EDID.
Video output connector — Connect an HDMI display device to this female Type A
HDMI connector.
The EDID information is read from the connected output device via this connector and
is written to memory on each input whenever the output device is connected this port
and powered on.
NOTE:
The EDID information is also read and stored whenever power is recycled
to the connected output device or when the output device is replaced.
3 4
cable lacing brackets, one for each HDMI input
®
SW HDMI Series • Installation
OUTPUT REMOTE
RS-232 AUTO
Tx Rx G
3 4
OUTPUT REMOTE
RS-232 AUTO
Tx Rx G
3 4
5