Replacing A Control Enclosure Chassis; Sas Cable - IBM Storwize V7000 Maintenance Manual

2. Pull the tab with the arrow away from the connector.
Figure 38. SAS cable
3. Plug the replacement cable into the specific port.
4. Ensure that the SAS cable is fully inserted. A click is heard when the cable is

Replacing a control enclosure chassis

This topic describes how to replace a control enclosure chassis.
Note: Ensure that you know the type of enclosure chassis that you are replacing.
The procedures for replacing a control enclosure chassis are different from those
procedures for replacing an expansion enclosure chassis. For information about
replacing an expansion enclosure chassis, see "Replacing an expansion enclosure
chassis" on page 105.
100
Storwize V7000: Troubleshooting, Recovery, and Maintenance Guide
successfully inserted.