NordicTrack Freestride Trainer FS3i User Manual page 22

HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, use
a standard
screwdriver and
pry the Outer Disc
(20) off the Left
Outer Shield (28).
Next, locate the Reed Switch (56). Turn the pedals until
a Magnet (65) on the Left Inner Disc (70) is aligned
with the Reed Switch.
70
56
125
Next, loosen the M5 x 16mm Screw (125) and slide
the Reed Switch (56) slightly closer to or away from
the Magnet (65). Then, plug in the power adapter and
move the pedals forward and backward so that the
Magnet passes the Reed Switch repeatedly. Repeat
these actions until the console displays correct feed-
back. Then, tighten the Screw.
When the reed switch is correctly adjusted, reattach
the left outer shield.
28
20
65
HOW TO ADJUST THE GLIDE CABLES
If the underside of a pedal arm touches the glide
cables when a person is standing on the pedals, the
glide cables on that pedal arm should be adjusted.
When you adjust the glide cables, you must tighten
the nuts the same number of turns on both glide
cables.
See EXPLODED DRAWING B on page 27. Identify
the Pedal Arm Covers C and D (16, 17). Remove the
M4 x 20mm Screw (136) and the four M4 x 16mm
Screws (98) from the Pedal Arm Covers; make sure to
note the location of each size of Screw.
Next, locate the indicated ends of the Glide Cables
(62). Hold one of the Glide Cables in place with a
wrench or a pair of pliers in the indicated location (A).
Then, use another wrench to tighten the nut (B) several
turns; make sure to count the number of turns that
you tighten the nut.
Repeat these actions to adjust the other glide cable;
make sure to tighten both nuts the same number of
turns. Then, have a second person stand on the ped-
als and check to see if the underside of the pedal arm
is still touching the glide cables.
Continue adjusting the glide cables until the pedal arm
no longer touches the glide cables when a person is
standing on the pedals. Then, reattach the pedal arm
covers.
Repeat these actions to adjust the glide cables on
the other pedal arm, if necessary.
22
17
16
B
62
A