NordicTrack Freestride Trainer FS3i User Manual page 11

8. Attach the Upper Tray Housing (19) and the
Lower Tray Housing (38) to the Upright (2) with
four M4 x 20mm Screws (136); do not fully
tighten the Screws yet.
9. Attach the Housing Cap (39) to the Upright (2)
and to the Upper and Lower Tray Housings
(19, 38) with two M4 x 20mm Screws (136); do
not fully tighten the Screws yet.
10. While a second person holds the Console
Bracket (3) near the Upright (2), insert the Main
Wire (45) and the Accelerometer Wire (48)
upward through the Console Bracket as shown.
Tip: Avoid pinching the wires. Slide the
Console Bracket (3) onto the Upright (2). Attach
the Console Bracket with three M10 x 20mm
Patch Screws (95); start all the Patch Screws,
and then tighten them.
See assembly steps 8 and 9. Tighten the
M4 x 20mm Screws (136).
8
38
9
10
95
48
11
19
2
136
2
136
39
19, 38
3
95
45
Avoid
pinching
2
the wires