94). Route The Strap Under The Roller (67 - NordicTrack Freestride Trainer FS3i User Manual

6. Identify the Strap (64) on the Right Pedal Arm

(94). Route the Strap under the Roller (67);

make sure that the Strap is not twisted.
Make sure that the Glide Cables (62) on the
Right Pedal Arm (94) are resting on top of the
Roller (67) and that the Strap (64) is routed
under the Roller.
Tip: It may be helpful to have a second
person press downward on the Right Pedal
(11) while you perform the following action.
Attach the Strap (64) to the Cable Guide (12) on
the Right Pedal Arm (94) with three M6 x 20mm
Patch Screws (42) and a Strap Clamp (13); start
all the Patch Screws, and then tighten them.
Then, attach a set of Pedal Arm Covers A and
B (14, 15) to the Right Pedal Arm (94) with five
M4 x 30mm Screws (135).
Repeat this step on the other side of the
elliptical.
7. Identify an Upper Body Arm (8), an Upper
Body Arm Cover (140), and the Right Leg
Cover B (36).
Slide the Upper Body Arm Cover (140) and the
Right Leg Cover B (36) onto the Upper Body
Arm (8) as shown.
Attach the Upper Body Arm (8) to the Right Leg
(5) with two M10 x 45mm Screws (78) and two
M10 Small Washers (132).
Next, slide the Right Leg Cover B (36) downward
and press it into place. Then, slide the Upper
Body Arm Cover (140) downward and press it
into place.
Repeat this step on the other side of the
elliptical. Tip: Avoid pinching the wires (not
shown).
6
135
135
15
94
12
13
42
7
8
140
10
11
62
67
64
14
135
78
132
78
132
5
36
135