SixThreeZero AROUND THE BLOCK Assembly Manual page 39

0 5
9 M M
M U LT I -TO O L
Now adjust the cable tension, which controls how your bike will shift. Using a 9mm
crescent wrench or the multi-tool, loosen the cable adjustment screw and pull on
the cable. While keeping tension on the cable, tighten the cable adjustment screw.
0 6
Rotate the pedals and try to shift between gears. If it doesn't shift from 7th to 6th
gear in one click, then the cable needs to be tightened. To tighten the cable, twist
the barrel adjuster counterclockwise 1/4 turn at a time until it is able to shift from 7th
to 6th gear in one click.
Shift through the gears from 7th to 1st, then back from 1st to 7th. If the gears feel
sluggish when shifting from 7th to 1st, tighten the cable by turning the barrel
adjuster counterclockwise. If shifting feels fine from 7th to 1st, but sluggish from 1st
to 7th, loosen the cable by turning the barrel adjuster clockwise.
Continue to adjust the derailleur cable until you are able to shift between each gear
with a single click.
WATC H A S S E M B LY V I D E O S O N O U R Y O U T U B E C H A N N E L , H T T P S : / / S I X T H R E E Z E R O . C O M / PA G E S / A S S E M B LY
N O T E
Each gear should shift with a corresponding
"click" sound.