Mounting The Switch On A Table; Checking After Installation - Ruijie Networks RG-S2628G-E Hardware Installation And Reference Manual

Mounting the Switch on a Table

Step 1: Attach the four rubber feet to the recessed areas on the bottom of the switch.
Step 2: Place the switch on the

Checking After Installation

Before checking the installation, switch off the power supply so as to avoid any personal injury or damage to the
component due to connection errors.

Check that the ground line is connected.

Check that the cables and power input cables are correctly connected.

Check that all interface cables are laid out inside the equipment room. In the case of external cabling, check that the lightning
resistance socket or network interface lightning protector is connected.

Check that sufficient airflow is available around the device (over 10 cm).
table.