Maintenance Schedule; Maintenance Checklist - Ventrac MS600 Operator's Manual & Parts Drawings

Maintenance Schedule

Maintenance
Schedule
Caster Wheel Pivot
Wheel Axle Bearing
Rear Roller Bearing
Jackshaft Bearing
Spindle
Hitch Pivot
Deck Slide
Hydraulic Flip-up Cylinder Ends
Flip-up Rocker Bracket
Inspect for Loose, Missing, or Worn Components
Inspect Belts, Pulleys, Blades, and Blade
Retaining Bolts. Torque to 100 ft-lbs (136 Nm)
Check Tire Pressure - 8-10 psi (55-69 kPa)
Check Hitch Pivot Bolts.
Torque to 151 ft-lbs (205 Nm)
Inspect Safety Decals
** Operation in severe conditions may require more frequent service intervals.
^ Grease Until Fresh Grease is visible
% Clean and relubricate with a thin film of grease

Maintenance Checklist

Maintenance
Checklist
Wheel Swivel Bearing
Wheel Axle Bearing
Rear Roller Bearing
Jackshaft Bearing
Spindle
Hitch Pivot
Deck Slide
Hydraulic Flip-up Cylinder Ends
Flip-up Rocker Bracket
Inspect for Loose, Missing, or Worn Components
Inspect Belts, Pulleys, Blades, and Blade
Retaining Bolts. Torque to 100 ft-lbs (136 Nm)
Check Tire Pressure - 8-10 psi (55-69 kPa)
Check Hitch Pivot Bolts.
Torque to 151 ft-lbs (205 Nm)
Inspect Safety Decals
** Operation in severe conditions may require more frequent service intervals.
^ Grease Until Fresh Grease is visible
% Clean and relubricate with a thin film of grease
SERVICE
Grease & Lubrication: See Lubrication Section
2 1
                   
2 ^ **
                   
2 1
                   
2 1
                   
3 3
                   
2 ^
                   
4 % **
                   
2 ^
                   
1 ^
                   



 

Grease & Lubrication: See Lubrication Section
2 1
2 ^ **
2 1
2 1
3 3
2 ^
4 % **
2 ^
1 ^
Inspection
  
Inspection
Service - 24
    