Mmu Ii Slave Configuration - EMS Sky Connect Series Installation Manual

4.4.2.2

MMU II Slave Configuration

Step
S1
S2
S3
S4
S5
S6
S7
S8
S9
S10
S11
S12
S13
S14
S15
S16
Procedure
Apply Power to the Slave MMU II Controller.
When the Screen displays the MMU Version and MSet version,
press and hold the * button (Upper Right) and press the main
KNOB in and turn one click counter-clockwise, then release both
the knob and the * button.
Rotate the Knob (do not press in) clockwise until the DIAL/In-Call
Mech: page appears.
The display probably is set at DTMF/DTMF.
Press the knob and release. The selection will begin to flash.
Rotate the knob until the Pots/NoTrkr is displayed.
Press the knob and hold. The screen will display "Value Saved
SUCCESS".
Rotate the Knob (do not press in) clockwise until the Volume Tap:
page appears.
The display probably is set at NOT ENABLED.
Press the knob in and release. The selection will begin to flash.
Rotate the knob until the selection Offhook displayed.
Press the knob and hold. The screen will display "Value Saved
SUCCESS".
Press the knob in and rotate clockwise one click. Release.
The screen should display Exit Settings Mode.
Press the knob in and release. The screen will now display MMU
Ready page.
Slave MMU II Configuration complete.
4 - 14
1616-964-12
Date: 7/27/2011
Rev. 2.1