Transceiver Pin Assignments - EMS Sky Connect Series Installation Manual

3.6.5 TRANSCEIVER PIN ASSIGNMENTS

The below Table is a listing of pin assignments and signal flows. This table applies
only to 1616-050-0XA transceivers. For non A models refer to older install manuals.
Pin Description
1 Ground Input
2 Reserved do not connect anything to
this pin
3 Comm Audio Lo
4 DPL Uplink
5 PC DCD (Data Connections only)
6 NC
7 Microphone Audio Hi
8 Program Stat --Factory Use Do Not
Connect
9 ISCM DPL Ground
10 Shield/Configure ground
11 Shield/Configure ground
12 Configuration Module Power
(3.3V)--Do Not Connect to other
than ICM/ICSM
13 Shield/Configure ground
14 Shield/Configure ground
15 Annunciator #1 –Sinks 100ma to
Ground
16 Annunciator #2 – Sinks 100ma to
Ground
17 Annunciator #3 – Sinks 100ma to
Ground
18 Annunciator #4 – Sinks 100ma to
Ground
19 Configure SDA
20 Event switch #1 – Gnd=Active
21 11-33VDC positive voltage input
Table 6
Flow 22 Ground Input
Gnd 23 No Connection
24 Program -TX-- Factory Use Do Not
Connect
Gnd 25 DPL Downlink
In 26 DPL Enable
Out 27 PC CTS (Data Connections only)
28 Configure SCL
In 29 Com Audio Hi
30 Diagnostics Gnd
31 RS232 #1 Gnd
Gnd
32 RS232 #2 Gnd
Gnd
33 Shield/Configure ground
Gnd
34 Program Md0--Factory Use Do Not
Out Connect
35 Shield/Configure ground
36 PC GND (Data Connections only)
Gnd
37 PC S TX (Data Connections only)
Gnd
38 PC DTR (Data Connections only)
Out
39 PC RTS (Data Connections only)
Out
40 Program Rx--Factory Use Do Not
Connect
Out
41 No Connection
42 11-33VDC positive voltage input
Out
43 Ground Input
44 No Connection
In
45 PC RI (Data Connections only)
In
46 PC DSR (Data Connections only)
3 - 10
1616-964-12
Date: 7/27/2011
Rev. 2.1
Gnd
Out
Out
Out
In
Out
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Out
In
In
Out
In
Gnd
Out
Out