EMS Sky Connect Series Installation Manual page 43

4.4.1.15 Volume Tap - Select from the following options:
1.) Not Enabled – neither offhook nor flash are enabled
2.) Offhook – allow taking phone offhook from ringer volume page
3.) Flash – allow flashing of the line (go onhook for 90 ms) from phone
volume page
4.) Offhook & Flash – allow both of these options
4.4.1.16 Messenger Protocol - Select the protocol version to be used between MMU
and the TRKR box. For proper operation until noted otherwise, Version 1
protocol should be enabled.
To exit from Configuration mode, push-n-turn the knob one detent to "Exit Settings
Mode", and then tap the knob back to the "MMU Ready" display.
A mechanism known as "pocket-config" is available to change volumes and levels
while in-call. To enable pocket-config, you must first enter Configuration mode, and
then exit Configuration mode (it does not matter if any settings are changed; only
that you were at one time in this mode). Once that is performed, pocket-config is
then enabled any time while in-call. While pressing one of the following keypad
keys, turn the knob to select:
1.) DTMF Output Volume
2.) Phones Volume
3.) Sidetone Level
4.) Microphone Volume
5.) Ringer Volume
6.) Ringer Sample – the ringer will be heard with a test ring.
4 - 11
1616-964-12
Date: 7/27/2011
Rev. 2.1