Examples Of Event Switch Usage - EMS Sky Connect Series Installation Manual

Examples of Event Switch usage would be;
Engine Oil Pressure
Low Rotor RPM
Engine Out
Engine Fire
Engine Chip
Gear Box Chip
Any of the above that will trigger a switch closeure, a ground to turn on a
lamp, can be used to trigger an event report from the Tracker. Relays may be
used to isolate "required" systems from "non required" or simply diodes.
The options and variation here are far too complex and vary to cover all of
them in a STC project. This type of interface will have to be approved by your
local airworthiness authority, and NOT from this manual as it is only
intended to be offered as a guide as to how to use these features.
4 - 20
1616-964-12
Date: 7/27/2011
Rev. 2.1