Configuration/Sim Module - EMS Sky Connect Series Installation Manual

the ICM is connected at startup, the configuration is read from the ICM. If it is
not present at startup, the system uses its internal memory which is
re-flashed by the ICM at startup when connected.
4.1.3

CONFIGURATION/SIM MODULE

The Configuration/SIM Module (ICSM) part number 1616-905-02, has the
same functionality as the Configuration Module but allows for the installation
of the SIM card into the module instead of the transceiver. With this setup no
card need be installed in the transceiver at all. This allows for the swapping
of the unit, and the SIM card to remain with the aircraft. No changes to the
aircraft's phone number. A secondary advantage would be if the customer
changed voice providers, the ICSM could be opened and the card installed,
eliminating maintenance to the transceiver itself.
NOTE: While the 9 pin female connector on the ICM/ICSM is
designed to be connected directly to a PC for programming,
the PC should not be connected directly to the 9 or 25 pin
female connector used to connect to the ICM/ICSM's male
connector. Only pins 2, 3, and 5 are used for configuration,
the remainder of the pins are used internally and damage
can be done to the Tracker and the PC if these lines are
connected to a PC inadvertently. See wiring diagrams.
4 - 2
1616-964-12
Date: 7/27/2011
Rev. 2.1