Table of Contents
Advertisement
2
Installation
2637_en_D
The flexibility of the Valueline IPC allows many different installation options.
2.1
Mounting and clearances
Depending on the configuration ordered, there are several ways to mount the VL IPC. Use
the appropriate section below to mount the VL IPC.
NOTE:
Install the VL IPC with adequate clearance around the heat sink to provide sufficient air
flow such that ambient temperatures do not exceed the operating limits listed in
Section 2.1.1, "Temperature specifications". Install cooling fan(s) in the enclosure, if
necessary.
When installing the VL IPC in a cabinet, follow these general rules:
–
Verify clearances within the cabinet. Typically, leave at least 5 cm (2 in.) on each side
with 12.7 cm (5 in.) on the connector side if the VL IPC has the optional optical storage
drive.
–
Drill all holes and make all cuts before beginning installation. Be sure to protect already
installed components from shavings.
–
Supporting panels must be at least 14 gauge to provide proper support.
–
Make sure that there is adequate space around the heat sink (on the back of the VL IPC)
and air inlets and outlets to provide sufficient cooling.
2.1.1
Temperature specifications
Operational temperature limits depend on the specific configuration of the Valueline IPC
(see Table 2-1 "Temperature limits" for details).
Table 2-1
Temperature limits
Configuration
Any processor with no display, 12-, 15- or 17-in.
display, solid state drive or CompactFlash
Any processor with no display, 12-, 15- or 17-in.
display and rotating hard drive
Any processor with 19- or 24-in. display, solid
state drive or CompactFlash
Any processor with 19- or 24-in. display and
rotating hard drive
Please be aware that adding PCI cards can add heat to the system.
Ambient range (operating)
-20°C ... 55°C (-4°F ... 131°F)
®
card
5°C ... 55°C (41° ... 131°F)
0°C ... 50°C (32° ... 122°F)
®
card
5°C ... 50°C (41° ... 122°F)
Installation
2-1
PHOENIX CONTACT
Hide quick links:
Advertisement
Table of Contents
