Table of Contents
Advertisement
Electrical connection
Any electrical work required to install this
hob should be carried out by a qualified
electrician or competent person, in accordance
with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the rating
plate.
Note:
In case of a direct connection to the mains you have
to interpose an omnipolar switch a minimum opening
between contacts of 3 mm.
The switch should be sited within 2 m of the hob and
be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
Ensure that the supply cord is not in contact with any
part of the hatched area shown in the diagram (see
figure).
NOTE: The earth wire should be about 4 cm
longer than the live and neutral wires.
To use cable type H05 RR-F with the section
indicated in the table no.1.
Environmental Information
All materials marked by the symbol
recycling. Store them in places especially foreseen
for this purpose (inform yourself at the services of
your area) for recovery and recycling.
In case of functioning anomalies it is the after
sales service of your dealer the first to intervene.
In case of moving to another place, closing of
the shop, contact the nearest Consumers
Service (Authorised Services Centre) who will
give you the address of an after sales service.
The symbol
on the product or on its
packaging indicates that this product may not be
20
Before connecting check that:
•
fuse and household electric installation can bear
the charge of the appliance (see rating plate);
How to proceed?
•
Unscrew and remove the protective cover at the
back of the appliance;
•
Connect the power cord to the terminal of the
cooker according to the table no.2;
•
Fix by means of cable clamp;
•
Make sure that the connection to the terminal is
matching the network power;
•
Remount and screw the protective cover at the
back of the appliance.
Table no.2
Connection type
Cable connection to the
Voltage of heating elements
treated as household waste. Instead it shall be handed
are
over to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product.
For more detailed information about recycling of this
product, please contact your local city office, your
household waste disposal service or the shop where
you purchased the product.
terminal plate
Network power
Fusible capacity
Cable section
Single phase
1 2 3 4 5
L1
N
230V
230V
10 A
3 x 4 mm²
Advertisement
Table of Contents
