Removing The Intake Manifold; Removing The Cylinder Head - PIAGGIO Liberty 50 Catalyzed Workshop Manual

Engine
N.B.
A VARIATION OF THE AIR GAP DISTANCE CAN LEAD TO
A VARIATION IN THE IGNITION ADVANCE SUCH AS TO
CAUSE PINGING, KNOCKING ETC.
Locking torques (N*m)
Flywheel nut
40 to 44 N.m
Refitting the starter motor
- Fit a new O-ring on the starter and lubricate it.
- Fit the starter motor on the crankcase and lock
the 2 screws to the prescribed torque.
N.B.
REFIT THE REMAINING PARTS AS DESCRIBED IN THE
CYLINDER HEAD, TIMING, LUBRICATION, FLYWHEEL
AND TRANSMISSION CHAPTERS.
Locking torques (N*m)
Starter screws
11 to 13
Cylinder assy. and timing system

Removing the intake manifold

Use an anti-tampering TORX spanner to remove
the two clamping screws of the intake manifold

Removing the cylinder head

Remove the 4 screws shown in the figure
ENG - 78
Liberty 50 Catalyzed