Water Pump Mechanical Seal Replacement - Honda CX650C 1983 Shop Manual

W B E R PUMP MECHANICAL
SEAL REPLACEMENT
Remove the engine rear cover (Page 8-21.
Drive the mechanical seal out from the inside being
careful not to damage the water pump body.
NOTE
COOLING SYSTEM
OIL SEAL MECHANICAL SEAL
Install a new rubber seal and seal washer if the
mechanical seal i s replaced.
MECI-4ANICAL SEAL
Apply a thin coat of liquid sealant to the outer edge
of a new mechanical seal.
NOTE
/
(s
Check that the water pump drain hole i s
clear.
Refer to page 9-1 2 for installation instruc-
tions using the tool available only in the
U.S.A.
Drive the mechanical seal into position in the rear
cover with the mechanical seal driver attachment
and bearing driver handle. Be careful not to damage
the water pump housing.
. - - - . p - - - . .
. -
. . . - - p
Assemble the driver as follows:
Install the seal driver attachment onto the
driver handle. Place the mechanical seal
into the attachment.
B
Drive in the seal scluareiy.
.s
To install the mechanical seal using the
special tool available in the U.S.A., refer to
the page 9-1
2.
install the rear cover (Page 8-10).
DRAIN HOLE
D R I V E R
07749-001 0000 or
07949-6 1 l0000
Date of Issue: December, 1982
O HONDA MOTOR CO., LTD.