Rod Side Clearance Inspection - Honda CX650C 1983 Shop Manual

CRANKSHAFT GAP
Remove the flywheel and cam chain (Page 10-2).
Remove the crankshaft cap bolts.
NOTE
Before removing the crankshaft, wrap the
splines of the primary gear and timing sprock-
e t with vinyl tape t o prevent damage t o the
main journal bearings.
. - - - p . - . . - p - . - . p . . - - p
VINYL. TAPE
CRANK CAP PULLER 07935-41 50000
(NOT AVAILABLE IN U.S.A.)
Attach the Crank Cap Puller t o the front of the
engine.
Press the crankshaft o u t by screwing in the Crank
Cap Puller, or use a press t o remove the crankshaft.
Be carefil not to damage the bearing when
removing the crankshaft.
Place the engine case in a hydraulic press on supports
s o that it is at least 2 inches above the adjustable
cross beam.
Press the crankshaft o u t while holding the crankshaft
cap.
ROD SIDE CLEARANCE INSPECTION
Install each connecting rod and bearing cap in its
original position and torque t o specifications evenly
in 2-3 steps.
TORQUE: 41--45
P4.m
(4.1--4.5 kg-m, 30-3"1t-lk)
Measure the rod side clearance with a feeler gauge.
SERVICE LIMIT: 0.50 mm (0.020 in)
Date of Issue: Decernber, 4982
O
HQNDA MOTOR CO., LTD.