Ignition Timing Adjustment - Honda CX650C 1983 Shop Manual

I
-
l e - z a n a n a
ALTERNATORlFLYWHEEL/
REAR
COVER
6X6506
- " - - ~
m - - m - -
- - - -
- - - - m - -
Install the spark advancer.
NOTE
/
Align the lug of the advancer with the
1
in the cfankshaft.
lighten the 6 mm bolt.
TORQUE: 8-32 M*m (0.8-1.2 kg-m,
cut-out
1
SPAR K ADVANCE R LUG
INDEX
"FS" MARK
MARK (R. SIDE)
RIGHT
P U L S E
GENERATOR
IGNITION TIMING ADJUSTMENT
Remove the timing inspection hole cap.
Rotate the crankshaft, and align the "FS" mark on
the right side with the index mark on the rear
engine cover.
Install the pulse generator assembly, aligning the
right pulse generator steel core with the rotor tooth.
Tighten the screws securely.
STEEL CORE ROTOR TOOTH
INDEX
"FS" M A R K
Rotate the crankshaft clockwise, and align the
"FS"
mark on the left side with the index mark on the
rear engine cover. Check that the rotor tooth is
aligned with the left pulse generator
steel
core.
Check the air gap between the rotor tooth and steel
core and adjust i f necessary (Page 18-6).
To adjust: Move the pulse Snerator to the right or
left by loosening the generator attaching screws.
"Tighten the attaching screws and recheck the gap.
Date
of Issue:
December,
2 982
o
cloiuaa
wroroR
CO.,
LTD.