Other Controls - Mitsubishi MELSEC-F Training Manual

Positioning Control
4.2

Other controls

In some models, controls in accordance with diversified special needs such as speed control,
position follow-up control and three-dimensional interpolation control shown below are
available.
Speed
Start point
Speed change in X axis
Speed
Start point
Speed change in X axis
Constant
quantity
End point
Time
< Speed control >
- After movement starts from the start
- Applicable models
X axis
- Application examples
Time
< Constant feed >
- After start, a workpiece moves by the
- Applicable models
X axis
- Application examples
Advanced Positioning 4
p o i n t , i t t h e n c o n t i n u e s a t t h e
s p e c i f i e d s p e e d u n t i l t h e s t o p
command is input.
[FX-1PG,FX -1PG
2N
AD75P1/P2/P3,AD75M1/M2/M3,
QD75P1/P2/P3,QD75D1/D2/D3,
A171SH,A172SH,A173UH,A273UH]
[Conveyor, carrier unit, roller feed,
crane, etc.]
specified constant quantity, but the
current value does not increase even
if the operation is repeated.
[FX-10GM,FX-20GM,E-20GM,
FX -10GM,FX -20GM
2N 2N
AD75P1/P2/P3,AD75M1/M2/M3,
A171SH,A172SH,A273UH]
[Press, shear, conveyor, transfer unit,
assembly line, etc.]
4-3