Drill & Mount - Wallbox Copper Type 1 Case C Installation Manual

DRILL & MOUNT
DRILLING TEMPLATE PROCEDURE
• Use the drilling template as a guide to mark the location on the wall for the mounting screws. Pay special attention
when levelling the template. The use of a spirit level is highly recommended.
• Drill the marked mounting holes with the diameter specified for the selected installation hardware and check the posi-
tioning of the holes. For installation on concrete, brick and wood walls, use the included installation hardware.
Make sure the power supply is turned off during all mounting steps
OPENING THE DEVICE
1. Unscrew the two screws on the bottom side of the frame
and remove it
2. Remove the 6 screws of the front cover
3 Open carefully the cover
4 Disconnect the cover communication cable.
BACKSIDE MOUNTING
IMPORTANT: In case your wallbox is using a backside-wall cable connection, please follow steps 0 and Step 00. If not using
such cable connection, please go to step1.
Step 0: In the backside of the wallbox charger you will find an insertion with a thinner wall; use a cutter, razor or a sharp tool
and carefully make an incision into the cable opening. Please meticulously remove all sharp edges. Take a Rutaseal bushing
and install it.
Step 00: Very carefully, firmly insert your cable supply through the bushing. Bush hole sealing is prepared for a range that
can vary from 11 to 17mm which falls within the standard for cables that can carry up to 22kW.
COPPER MOUNTING
Step 1: Use the selector on the cover to choose the maximum operating current of the supply connection.
Step 2: Proceed to fix your charger to the wall. Insert the screws in the positions marked,
starting with the top one, and continuing clockwise.
Verify that your Wallbox is firmly attached and insert the plugs to complete this process.
COPPER - installation guide
8
POSITION 0 1 2
CURRENT (A) 0 6 10
en
3 4 5 6 7 8 9
13 16 20 25 32 0 0