Drill & Mount - Wallbox PULSAR Installation Manual

DRILL & MOUNT 1/3
DRILLING TEMPLATE PROCEDURE
Use the drilling template as a guide to mark the location on the wall for the three mounting screws. Pay special attencion when leveling the
template. The use of a spirit level is highly recommended.
Drill the marked mounting holes with the diameter specified for the selected installation hardware
and check the positioning of the holes. For installation on concrete, brick and wooden walls,
use the included installation hardware.
Before you start mounting:
Open the cover carefully
Disconnect the communication cable from the cover
Insert the rubber plugs in the cavities undearneath
Make sure the power supply is turned o during the mounting process
MOUNTING
IIMPORTANT: In case your Wallbox is using a backside-wall cable connection, please follow steps 0 and Step 00. If not using such cable connection
please go to step 1.
Step 0: In the backside of the Wallbox charger you will find an insertion with a thinner wall; use a cutter, razor or a sharp tool and carefully make an
incision into the cable opening. Please meticulously remove all sharp edges. Take a Rutaseal bushing and install it.
Step 00: Very carefully, firmly insert your cable supply through the gasket. This gasket is prepared to run through cables that can vary from 11 to
17mm, which falls within the standard for cables that can carry up to 22kW.
PULSAR
- installation guide en 13