Dimensions & Positioning; Drill - Wallbox PULSAR Installation Manual

DIMENSIONS & POSITIONING
Be fore selecting the mounting situation of your Wallbox, please read the following tips and
references:
According to the product standard, the charging station must be located at a height
(y) between 1,3m and 1, 7 m. We recommend mounting the charging station at a height
of 1, 6 m.
Keep in mind that local regulations can limit this height.
It is compulsory to consider the following precautions:
• The required mounting area for the Wallbox charging station is at least 250x150mm
(HxW).
• When mounting the Wallbox, the cable should easily reach the vehicle inlet.
• For a safe operation of your charging station, the recommended minimum distances
to other technical installations must be observed.
• Note that when you install the support for the charger connector, you have enough
space to facilitate the ergonomics. It is advisable to have a free area around the
device of 400x400mm.
Proper installation is absolutely necessary and is beyond the scope of liability of Wallbox

DRILL

DRILLING TEMPLATE PROCEDURE
• Use the drilling template as a guide to mark the location on the wall for the mounting screws. Pay special attention when
levelling the template. The use of a spirit level is highly recommended.
• Drill the marked mounting holes with the diameter specified for the selected installation hardware and check the positio-
ning of the holes. For installation on concrete, brick and wood walls, use the included installation hardware.
PULSAR - installation guide
Installation video available at wallbox.com/installation
Make sure the power supply is turned off during all mounting steps
150 150
en 7