Lenovo EN4023 User Manual page 24

2
Installing the switch
7.
8. Push the release levers on the front of the switch to the closed position. After you insert and
9. To install another switch, repeat
12
1
2
2
1
1 Release lever
FIGURE 2
Switch release levers and locks
Slide the switch into the bay until it stops.
lock the switch, it turns on, and a power-on self-test (POST) occurs to verify that the switch is
operating correctly. The POST takes approximately 5 minutes to complete.
During POST, the switch LEDs will go through a lamp test. When the switch has completed
POST, all LEDs except the OK LED will power off and follow normal operation. Refer to
the information panel, LEDs, and external ports"
NOTE
To maintain proper airflow, make sure the ventilation holes on the front of the switch are not
blocked.
2 Release lever lock
on page 20 for more information.
step 2 through step 8; otherwise, go to the next step.
Lenovo Flex System EN4023 10Gb Scalable Switch User's Guide
"Locating