Reassembling The Wheel Motor; Fit The Floating Seal - Kubota U20-3 Workshop Manual

U20-3, U25-3 WSM

3) Reassembling the wheel motor

1. Fit the floating seal

1) Temporarily set the floating seal using the
guide jig (see the figure below).
(1) Floating seal
(2) Flange holder
(3) Guide jig
2) Fit the floating seal using the mounting jig
(see the figure below).
(1) Flange holder
(2) Mounting jig
(3) Guide jig
2. Place the other floating seal concentrically.
(1) Floating seal
3. Press-fit the angular bearing into the flange
holder using the mounting jig (see the figure
below).
(1) Angular bearing
(2) Flange holder
(3) Mounting jig
IV-S-115
Hydraulic system (Service section)