Cleaning And Oiling - Siruba HSP-68100 Instructions Manual

Screw
Clean the shuttle race
Clean shuttle race saddle
Fixed point
Screw
Take up lever
Clean the feed dog
Stop point

CLEANING AND OILING

Note: Pull stehts net-put for the machine if it out of
operation are, if the lamp replaced or if them
are cleaned.
Pull out power supply plug before clearing. In order to
maintain it's to effective functions and pro-long
working life. This machine must be properly
maintained and cleaned and oiled after use.
1. Take off the needle plate by loosening the screws
on both sides.
2. Turn the hand wheel until the thread take-up lever
reaches the highest point.
3. Take out the bobbin case. Brush away fluff and lint
around feet dog, bobbin case and shuttle race.
4. Assembling the bobbin case. The "fixed point"
should be on the left side of "stop point", as
illustrate.
- 34 -