Table of Contents
Advertisement
HOW TO REMOVE AND ATTACH
THE SHANK
Raise the presser foot.
Turn the screw counterclockwise with the screwdriver
to remove the shank.
When attaching, place shank on presser bar. Lower
the presser foot lever. Turn screw clockwise to tighten.
REPLACING PRESSER FOOT
1. Turn off power.
2. Raise needle bar to its highest position and raise
the presser foot.
3. Press release lever as shown, remove presser
foot.
1. Place the presser foot pin right under the groove
of the foot holder.
2. Lower the presser lever.
3. Press the presser lever, the lever bar will attach
the foot.
- 7 -
Advertisement
Table of Contents
