Table of Contents
Advertisement
Fault Code 30
Lid Lock unable to Lock – (User Warning).
Reason:
The lid lock failed to lock. (Not user displayed.)
Remedy:
(1) Ensure the lid is closed and the tongue engaged.
(2) Replace the lid lock harness.
(3) Replace the lid lock.
(4) Replace the sensor module.
Fault Code 45
Display Module ROM Check Error
On power up, the display has checked its memory against a known reference and found
differences.
Remedy:
Replace the display module.
Fault Code 105 Comms Error Time Out
Communications failure between the sensor module and display module.
Remedy:
(1) Visually check the contacts on the RAST (edge) connector at each end on
(2) Using a multimeter, check for continuity of the wires in this harness.
(3) Replace the display module.
(4) Replace the sensor module.
Fault Code 233 EEPROM Read Error (LCD models only)
The sensor module has problems reading the EEPROM data in the display module.
Remedy:
Replace the display module.
Notes:
1.
If the dryer has stopped mid cycle with the Wrinkle Free LED illuminated, the LCD
screen (LCD models) or display LEDs (LED models) blank, and no fault "beeps", the
dryer may be experiencing a low voltage supply. At such a level the dryer cannot
function. Once the line voltage returns to normal, the dryer will recommence the
interrupted cycle.
2.
If the power supply has been turned off, the dryer may momentarily display the state
described in Note 1 prior to fully shutting down.
the harness between the sensor module and display module.
15
517760C
Hide quick links:
Advertisement
Table of Contents
