Fault Code Summary - Fisher & Paykel AeroSmart DE62T27CW1 Servlce Manual

517760C
User Warnings
There are two possible user warnings.
1. The machine is beeping and the lidlock light is flashing:
Close the lid and press Start/Pause.
If the lid is already closed, open and close it again, then press Start/Pause.
Disconnect from the power (either by unplugging the dryer or turning off at the power
supply). Wait 10 seconds. Reconnect and try turning the dryer on again.
2. The machine is beeping and the Time Dry 20 min is flashing:
The machine is unable to close the drum due to clothes interfering with the closing
mechanism. Remove any articles that are interfering with the drum door and dry these in
the next load.
Is the load higher than the lint bucket? Remove some articles and dry these in the next
load.
6.3

Fault Code Summary

The following are the fault codes that may be displayed. The remedy section of each fault is the
suggested sequence of repair or replacement. If the first suggestion does not remedy the fault,
check the next on the list.
Fault Code 1 Communications Error.
Communications failure between the sensor module and motor control module.
Remedy: (1) Check the continuity of the module interconnecting harness.
(2) Replace the sensor module.
(3) Replace the motor control module.
Fault Code 2 Drum Gap Cannot be Located.
Remedy: (1) Ensure the sensor module is correctly located and clipped into place.
(2) Replace the sensor module.
(3) Remove the top deck and clean the drum sensing "bumps" on the outside of
(4) Replace the drum.
Fault Code 3 Drum Stalled.
Remedy: (1) If there is mechanical movement of the drum, but this fault code is appearing,
(2) If there is no mechanical movement of the drum, check drum movement
(3) Replace the motor control module.
(4) Replace the motor.
Fault Code 4 Invalid Option Link Read.
The motor control module heat source option link read is invalid.
Remedy: Replace the motor control module.
Fault Code 6 Door Jammed – (User Warning).
The door is unable to close due to either clothes catching or an excessive closing load.
Remedy: (1) Remove the obstruction.
(2) Reposition or remove some of the load.
(3) Fix the cause of binding in the door closing mechanism.
(4) Replace the motor.
the drum end.
follow the procedures for fault code 2.
mechanisms: belt, motor and motor harness.
12