Canon DR-9080C Service Manual page 136

CHAPTER 4 INSTALLATION & MAINTENANCE
No.
12 Connect the connector located at the tip of the
IP carriage cable assembly to J412 of the
pick-up control PCB (80_SUB) on the main
body.
13 Check that the IP carriage can move from side
to side. In the lower frame of the IP carriage
there are small round grooves, and the IP
carriage moves back and forth while stopping at
each groove.
Note: The IP carriage should stop at each of
the grooves.
14 Install the upper delivery cover assembly.
Note: The upper delivery cover assembly
should be installed with the imprinter
cover opened.
15 Attach the right and left covers, and the rear
cover.
4 - 8
Procedure
COPYRIGHT © 2003 CANON ELECTRONICS INC. CANON DR-6080/9080C FIRST EDITION OCT. 2003
Inspection/Remarks
J412