Stop The Measurement; Store Data - Kimo DB 200 User Manual

E3 : this screen reminds the general format of the session of measurement:
Start : date of measurement start
•
End : date of measurement end (here, not entered because measurement is still ongoing).
•
Time : measurement time (here, not entered because measurement is still ongoing).
•
Mode : measurement mode type (here, L-Stock)
•
Weig. : weighting frequency type (here, A)
•
Cst : time weighting (here, F)
•
Lpk : weighting frequency type of the peak sound level (here, C)
•
Samp. : sampling rate (here, 01s)
•

5.2.4 Stop the measurement

We stopped the measurement manually through the
Note : The manual command (Start - Stop) has priority over the I/O command (even if the initial choice is a start from the I/O
command).
The pause function is inoperative.

5.2.5 Store data

At the end of the measurement, in manual mode, a screen of all results is displayed. It is then possible to :
➢ Accept measurements and store them : move the cursor on Sto. and press once on OK key to confirm. A banner displays the
storage phase.
Ongoing
measurement
➢ Reject measurements and not store them : move the cursor on RST and press twice on OK key to confirm. A banner displays
the phase of suppression of data.
Ongoing
measurement
Make some measurements
pictogram.
Results
Results
Deletion
Screen 3
Storage
RST active
12