Hp Trusted Platform Module - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Connect each power cord to the server.
18.
Connect each power cord to the power source.
19.
Press the Power On/Standby button.
20.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
After you replace the system board, you must re-enter the server serial number and the product ID:
During the server startup sequence, press the F9 key to access UEFI System Utilities.
1.
Select System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options >
2.
Advanced System ROM Options > Serial Number, and then press the Enter key.
Enter the serial number and press the Enter key.
3.
The following message appears:
The serial number should only be modified by qualified service personnel.
This value should always match the serial number located on the chassis.
To clear the warning, press the Enter key.
4.
Enter the serial number and press the Enter key.
5.
Select Product ID.
6.
The following warning appears:
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
7.
To confirm exiting System Utilities, press the F10 key.
8.
The server automatically reboots.

HP Trusted Platform Module

The TPM is not a customer-removable part.
CAUTION: Any attempt to remove an installed TPM from the system board breaks or
disfigures the TPM security rivet. Upon locating a broken or disfigured rivet on an installed
TPM, administrators should consider the system compromised and take appropriate measures
to ensure the integrity of the system data.
If you suspect a TPM board failure, leave the TPM installed and remove the system board. Contact a
Hewlett Packard Enterprise authorized service provider for a replacement system board and TPM board.
Removal and replacement procedures 61