WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the bezel
3.
Place the server on its side with the access panel facing up.
4.
If installed, unlock and remove the Kensington security lock.
5.
Remove the access panel:
6.
Loosen the access panel thumbscrew.
a.
Slide the access panel back.
b.
Lift the access panel away from the chassis.
c.
To replace the component, reverse the removal procedure.
Tower bezel
To remove the component:
Unlock the bezel.
1.
Open the bezel.
2.
("Unlock and remove the
bezel" on page 26).
Removal and replacement procedures 27