Non-Hot-Plug Drive Cage Bracket - HP ProLiant DL320e Gen8 v2 Maintenance And Service Manual

Remove the drive cage backplane.
b.
If you are removing the four-bay SFF drive backplane:
7.
If an HP CS power supply is installed, remove the power supply distribution board
a.
-48 V DC power supply enablement
Disconnect all cables from the drive cage.
b.
Remove the drive cage backplane.
c.
To replace the component, reverse the removal procedure.

Non-hot-plug drive cage bracket

To remove the component:
Power down the server (on page 28).
1.
Remove the power from the server:
2.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Remove the server from the rack (on page 30).
3.
Remove the access panel
4.
Remove the drive cage assembly.
5.
kit" on page 62).
("Access panel" on page 35).
("HP 750 W CS
Removal and replacement procedures 42