Fan Locations - HP ProLiant ML30 Gen9 Maintenance And Service Manual

Item LED
IMPORTANT: The Dynamic Smart Array B140i Controller is only available in UEFI Boot
Mode. It cannot be enabled in Legacy BIOS Boot Mode. If the B140i controller is disabled,
drives connected to the system board Mini-SAS connectors operate in AHCI or Legacy mode.
Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to enable or disable the
B140i controller (System Configuration → BIOS/Platform Configuration (RBSU) → System
Options → SATA Controller Options → Embedded SATA Configuration).

Fan locations

Fan number
1
2
Status Definition
Solid amber The drive has failed.
Off The drive is not configured by a RAID controller.
Fan type
System fan
Front PCI fan (optional)
Component identification 77