Winterhalter GS630 Manual page 19

Display
The temperature in the boiler or the
tank is above 95°C.
 Switch off the machine
immediately. The error code Err 2
Flashes in
or Err 3 is displayed.
red
In case of inadequate pre-cleaning of
the dish, dirt can get accumulated on
the strainer and in the filter cassette
such that the washing programme is
disturbed.
Flashes in
The circulating pumps switch off and
blue
the programme key (6) flashes in blue.
9.2 Malfunctions
Error
Machine cannot be
switched on
Machine does not get
filled
The dishes do not get
clean
There is formation of
layers on the dishes
The dishes do not dry
on their own
Meaning
Possible cause
The local mains disconnector is not
switched on
Local fuses defective
Machine door not closed completely Close the machine door
Water shut-off valve closed
No or excessively low detergent
dosing
Dishes incorrectly sorted
Nozzles of the wash arms blocked
Incorrect mode selected
Excessively low temperatures
In case of grease residues:
The water is too hard
In case of starch residues:
Excessively high temperatures
during manual pre-cleaning (fizzy
liquid)
No or excessively low rinse aid
dosing
English
Remedy
 Forward the error message to the Winterhalter
service engineer
 Switch off the machine; the programme key
continues to flash.
 Remove, clean and re-position the filters.
 The flashing stops after 1 minute. Switch on the
machine again and operate it.
 Ensure better pre-cleaning to prevent any more
malfunctions.
Remedy
Switch on the local mains disconnector
Repair the local fuses
Open the water shut-off valve
Set the dosing amount as per the
manufacturer's specifications
Check the dosing lines (for kinks,
breakage, ...)
Replace the storage container
Check the dosing device
Do not stack dishes one over the other
Remove the wash arms and clean the
nozzles
Use the intensive mode
Check the temperatures and if the desired
values have not been attained, inform the
Customer Service
Check the external water preparation / set
it correctly
Clean thoroughly
Maximum temperature may be 30°C
Set the dosing amount as per the
manufacturer's specifications
Check the dosing lines (for kinks,
breakage, ...)
Replace the storage container
Check the dosing device
Malfunctions
41