Executing The Regeneration - Miele PG 8536 Operating Instructions Manual

Water softener

Executing the regeneration

^ Close the door.
^ Select and start the
program.
In operating level C, you must start
the regeneration using the context
menu. To do so:
Open the context menu.
- Select the menu item
REACTIVATION
OK.
The system will automatically execute
the regeneration.
The water pressure (flow pressure at
the dispenser) must be at least
150 kPa (22 PSI).
If the flow pressure is lower than
150 kPa (22 PSI) or highly
fluctuating, the water softener
cannot be properly regenerated. In
this event, salt may be still be
present in the salt container after
regeneration.
Execute the menu option
REACTIVATION
complete dissolution of the salt and
to flush the softener.
30
REACTIVATION
and confirm with
again for a
Then:
^ Switch off the washer-disinfector.
^ Open the door.
^ Carefully unscrew the salt container
in order to any water presser to
subside. Do not use force!
If the container cannot be removed
manually, contact Miele Service.
^ The salt container must be emptied
outside the wash cabinet.
Salt brine and salt residue in the
wash cabinet may cause corrosion
and must be flushed immediately by
starting a short rinse cycle.
^ Screw the softener lid back on.
^ Insert the mobile unit.
^ Wash and rinse the salt container
and the filter cap with clear water.