Reactivation Display; Refilling The Softener With Salt - Miele PG 8536 Operating Instructions Manual

Water softener

Reactivation display

Reactivation
If the
in the display after the respective
rinsing process, the built-in water
softener is exhausted and cannot
supply any more softened water. Imme-
diately after the end of the program it
must be regenerated with reactivation
salt.
If this is not possible for operational
reasons and further rinsing sequences
have already been performed,
regenerate twice in succession.
28
message appears

Refilling the softener with salt

Only use special, coarse-grained
reactivation salt, or pure evaporated
salt with a grain size of 1 - 4 mm.
NEVER use other types of salt, such as
table salt, cattle salt, or de-icing salt.
These salts can contain components
that are insoluble in water and which
could damage the water softener.
The salt container holds approximately
2 kg of salt.
If only pure evaporated salt with a
fine grain size is available, please
consult Miele Service.
Pure evaporated salt with a grain
size larger than 4 mm cannot be
used.
,
NEVER fill detergent or similar
into the salt container.
This can lead
- to the water softener being
destroyed and
- to clogging of the filter cap.
The result is a pressure build-up in
the salt container. There is a risk of
chemical burns as well as a risk of
injury due to an alkaline solution
when removing the salt container.
Prior to filling the salt container,
please make sure that you are
holding a salt packet in your hand.