Safety Instructions And Warnings - NETGEAR MS510TX Hardware Installation Manual

8-Port Multi-Gigabit Smart Managed Pro Switch with two 10G Ports
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs.
• NETGEAR green power-saving features:
- Energy efficiency mode that fully conforms to the IEEE802.3az standard
- Per-port automatic change to a lower power mode when the port link is down

Safety Instructions and Warnings

Use the following safety guidelines to ensure your own personal safety and to help protect your system from
potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following
precautions:
• This product is designed for indoor use only in a temperature-controlled (0–50°C) and humidity-controlled
(90 percent maximum relative humidity, noncondensing) environment.
Any device that is located outdoors and connected to this product must be properly grounded and surge
protected.
To the extend permissible by applicable law, failure to follow these guidelines could result in damage
to your NETGEAR product, which might not be covered by NETGEAR's warranty.
• Observe and follow service markings:
- Do not service any product except as explained in your system documentation.
- Opening or removing covers that are marked with the triangular symbol with a lightning bolt can
expose you to electrical shock. We recommend that only a trained technician services components
inside these compartments.
• If any of the following conditions occur, unplug the product from the electrical outlet and replace the part
or contact your trained service provider:
- The power cable, extension cable, or plug is damaged.
- An object fell into the product.
- The product was exposed to water.
- The product was dropped or damaged.
- The product does not operate correctly when you follow the operating instructions.
• Keep your system away from radiators and heat sources. Also, do not block cooling vents.
• Do not spill food or liquids on your system components, and never operate the product in a wet
environment. If the system gets wet, see the appropriate section in your troubleshooting guide, or contact
your trained service provider.
• Do not push any objects into the openings of your system. Doing so can cause fire or electric shock by
shorting out interior components.
Introduction
7