Back Panel; Leds - NETGEAR MS510TX Hardware Installation Manual

8-Port Multi-Gigabit Smart Managed Pro Switch with two 10G Ports
Table 2. Front panel components model MS510TXPP (Continued)
Number Description
9 Two LEDs for Port 10. These LEDs indicate link, speed, and activity (see
10 USB 2.0 port (see

Back Panel

The switch integrates a fixed, internal power supply unit (PSU).
The back panel contains a Kensington lock slot, a console port that is not for customer use (it is for NETGEAR
technical support only), and the AC power connector.
Figure 3. Back panel

LEDs

This section describes the LED designations of the switch.
The following table describes the LEDs on the front panel of model MS510TX. Ports 1–9 come with a single
LED each. Port 10 comes with two LEDs.
Table 3. LEDs on the front panel of model MS510TX
LED Description
Power LED Solid green. The device is powered on.
Solid yellow. The device is booting.
Off. Power is not supplied to the device.
Fan LED Solid green. The fan is operating normally.
Solid yellow. A problem occurred with the fan.
1G Ports 1–4 LEDs Off. No link is established.
Link, speed, and activity Solid green. A valid 1000 Mbps link is established.
Blinking green. The port is transmitting or receiving packets at 1000 Mbps.
Solid yellow. A valid 10 Mbps or 100 Mbps link is established.
Blinking yellow. The port is transmitting or receiving packets at 10 Mbps or
100 Mbps.
USB Port on page 17).
Hardware Overview
12
LEDs on page 12).