Factory Defaults Button; Usb Port - NETGEAR MS510TX Hardware Installation Manual

8-Port Multi-Gigabit Smart Managed Pro Switch with two 10G Ports
The switch reboots.

Factory Defaults Button

To return the switch to its factory default settings:
1. Insert a device such as a straightened paper clip into the opening.
2. Press the recessed Factory Defaults button for more than three seconds.
The switch reboots and returns to its factory default settings.

USB Port

The switch provides one USB 2.0 port that lets you upgrade firmware from a disk and back up the configuration
to a storage device.
A device that you attach to the USB port must comply with the following requirements:
• The USB device must support USB 2.0.
• The USB device must support the FAT32 file type. The NTFS file type is not supported.
Hardware Overview
17