Leds Model Ms510Txm; Back Panel Model Ms510Txm - NETGEAR MS510TXM Hardware Installation Manual

8-Port Multi-Gigabit/10G Ethernet (Ultra60 PoE++) Smart Managed Pro Switch with 2 SFP+ Ports

LEDs model MS510TXM

The following table describes the LEDs on the front panel of model MS510TXM. Ports
1–8 each provide a left LED only. Ports 9F and 10F each provide a single LED.
Table 2. LEDs on the front panel of model MS510TXM
LED Description
Power LED Blinking green: The switch is booting.
Solid green: The switch is powered on and operating normally. If you changed the
management mode of the switch to NETGEAR Insight, the switch is not yet added to an
Insight managed network or not yet connected to the Insight cloud management server.
Solid blue: The management mode of the switch is NETGEAR Insight, the switch is added
to an Insight managed network, and the switch is connected to the Insight cloud
management server. You can manage and monitor the switch using the NETGEAR Insight
app or Insight Cloud portal.
Off: Power is not supplied to the switch.
Fan LED Solid green: The fans are operating normally.
Solid yellow: A problem occurred with the fans.
Ports 1–4, left LEDs Off: No link is established.
Link, speed, and Solid green: A valid link at a speed of 2.5 Gbps is established.
activity Blinking green: The port is transmitting or receiving packets at 2.5 Gbps.
Solid yellow: A valid link at a speed of 100 Mbps or 1000 Mbps is established.
Blinking yellow: The port is transmitting or receiving packets at 100 Mbps or 1000 Mbps.
Ports 5–8, left LEDs Off: No link is established.
Link, speed, and Solid green: A valid link at a speed of 10 Gbps is established.
activity Blinking green: The port is transmitting or receiving packets at 10 Gbps.
Solid yellow: A valid link at a speed of 5 Gbps, 2.5 Gbps, 1000 Mbps, or 100 Mbps is
established.
Blinking yellow: The port is transmitting or receiving packets at 5 Gbps, 2.5 Gbps,
1000 Mbps, or 100 Mbps.
Ports 9F and 10F, LEDs Off: No module is installed in the SFP+ port or no link is established on the SFP+ port.
Link, speed, and Solid green: The module in the SFP+ port established a valid link at a speed of 10 Gbps.
activity Blinking green: The module in the SFP+ is transmitting or receiving packets at 10 Gbps.
Solid yellow: The module in the SFP+ port established a valid link at a speed of 1 Gbps.
Blinking yellow: The module in the SFP+ is transmitting or receiving packets at 1 Gbps.

Back panel model MS510TXM

The switch integrates a fixed, internal power supply unit (PSU).
The back panel contains a Kensington lock slot and the AC power connector for power
input of 100–240V ~ 50–60Hz. The PSU draws 2.0A max.
Hardware Overview 13 Hardware Installation Guide