Installation; Placing; Rating Plate - ESAB Tig 150i Instruction Manual

GB
4.1 Parameter setting
Settings
Welding method
2/4--stroke
HF / Lift Arct
Slope down time
Gas post--flow
Current TIG Tig 150I
Current TIG Tig 200I
Current MMA Tig 150I
Current MMA Tig 200I
5

INSTALLATION

The installation must be executed by a professional.
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user's responsibility to take adequate precautions.
Note!
Connect the power source to the electricity mains with a network impedance of 0.210 ohm or lower. If the
network impedance is higher, there is a risk of flicker in the illuminators.
5.1

Placing

Place the power source so that its cooling air inlets and outlets are not obstructed.
5.2

Rating plate

The rating plate is located on the underside of the power source or on the rear plate.
bt26d2e
Setting range
TIG or MMA
2 stroke or 4 stroke
HF or LiftArct
0--10 s
0--25 s
3 -- 150 A
3 -- 200 A
3 -- 150 A
4 -- 150 A
- - 6 - -
In steps of:
--
--
--
0.1 s
0.1 s
1 A
1 A
1 A
2 A
Default value
TIG
2--stroke
HF
1.0 s
2.0 s
100 A
100 A
60 A
100 A