Cable Length - Siemens CPU 313C Hardware And Installation Manual

6WXE FDEOHV
If bus nodes are connected to a bus segment via stub cables (e.g. PG via a normal
PG cable), then you must consider the maximum possible length of the stub cable.
You can use a PROFIBUS bus cable with bus connector as the stub cable for up to
3 Mbps.
Use the patch cord to connect the PG or PC when operating above 3 Mbps. In your
bus configuration you can use multiple PG patch cords with this order no. Do not
use other types of stub cable.
7KH PD[LPXP FDEOH OHQJWKV IRU 3* SDWFK FRUGV 
... can be found in the Chapter &DEOH OHQJWKV.
 &DEOH /HQJWK
03, VXEQHW VHJPHQW
You can implement cable lengths of up to 50 m in an MPI subnet segment. This
50 m applies from the first node to the last node in the segment.
Table 5-24
7UDQVPLVVLRQ UDWH
19.2 kbps
187.5 kbps
1.5 Mbps
3.0 Mbps
6.0 Mbps
12.0 Mbps
6HJPHQW LQ WKH 352),%86 VXEQHW
The cable length in a segment of a PROFIBUS subnet depends on the
transmission rate.
Table 5-25
9.6 kbps to 187.5 kbps
500 kbps
1.5 Mbps
3 Mbps to 12 Mbps
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
A5E00105492-03
Permitted cable lengths in an MPI subnet segment
6 &38V QRQLVRODWHG
03, LQWHUIDFH ZLWKRXW &38
50 m
-
Permitted cable lengths in a PROFIBUS subnet segment
7UDQVPLVVLRQ UDWH
 '3
1,000 m
M 200
M 100
0D[LPXP FDEOH OHQJWK LQ D VHJPHQW
1,000 m
M 400
M 200
M 100
&RQILJXULQJ
&38  '3
5-41