Siemens CPU 313C Hardware And Installation Manual page 132

&RPPLVVLRQLQJ
7ULJJHU FRQGLWLRQ
• The "Trigger condition for monitoring" determines whether to update values
once when the trigger point is reached or continuously every time the trigger
point is reached.
• The "Trigger condition for controlling" determines whether to assign control
values once or permanently to the variable to be controlled.
You can customize the trigger points using the tool "Monitor and control variable" in
menu item 9DULDEOH ! 6HW 7ULJJHU  start.
6SHFLDO IHDWXUHV
• If "Trigger condition for monitoring" is set to RQFH , the menu items 9DULDEOH !
8SGDWH VWDWXV YDOXH or 9DULDEOH ! 0RQLWRU have the same effect, namely a
single update.
• If "Trigger condition for controlling" is set to RQFH , the menu items 9DULDEOH !
8SGDWH FRQWURO YDOXH or 9DULDEOH ! &RQWURO have the same effect, namely a
one-time assignment.
• If trigger conditions are set to SHUPDQHQW , the said menu items have different
effects as described above.
• If monitoring and controlling is set to the same trigger point, monitoring is
executed first.
• With some CPU versions (e.g. CPU 314-1AE03) values are not assigned at
every cycle when SHUPDQHQW FRQWURO is set.
Remedy: Use the testing function )RUFH.
6DYLQJ2SHQLQJ WKH 9DULDEOH 7DEOH
6DYLQJ WKH 9$7
1. After you abort or complete a test phase, you can save the variable table to
memory. The name of a variable table starts with the letters VAT, followed by a
number from 0 to 65535; e.g. VAT5.
2SHQLQJ WKH 9$7
1. Select the menu item 7DEOH ! 2SHQ .
2. Select the project name in the 2SHQ dialog.
3. In the project window below, select the relevant program and mark the %ORFNV
container.
4. In the block window, select the desired table.
5. Confirm with 2..
9-20
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
A5E00105492-03