Unlocking The Front Connector And Removing The Module - Siemens CPU 313C Hardware And Installation Manual

5HPRYLQJ D PRGXOH 60)0&3
Remove the module as follows:
6WHS
1.
2.
3.
4.
5.
6.
7.
Figure 10-1 Unlocking the front connector and removing the module
 Remove labeling strips.
 Open module.
Press unlocking mechanism/loosen mounting screw, and pull out front connector.

 Remove mounting screw of module and tilt module out.
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
A5E00105492-03
SLQ IURQW FRQQHFWRU
Switch the CPU to STOP.
Switch off the load voltage to the module.
Remove the labeling strip from the module.
Open the front panel.
Unlock the front connector and remove it.
Press down the unlocking
mechanism with one hand and with
the other hand, pull out the front
connector at the grips.
Undo the module fixing screw(s).
Swing the module out.
P S
C P U
7KLV ILJXUH LOOXVWUDWHV WKH VWHSV GHVFULEHG
SLQ IURQW FRQQHFWRU
Remove the fixing screw from the middle
of the front connector. Pull the front
connector out, holding it at the grips.
3
1
2
4
0DLQWHQDQFH
10-5