Table of Contents
Advertisement
14
OPERATING MANUAL STIMAWELL® 120MTRS
7.
Switch on the StimaWELL
the ON/OFF switch which is located on the rear side of
the control unit.
8.
About 2 seconds after switching on the Sti-
®
maWELL
120MTRS Control Unit there appears the
start screen. The starting procedure lasts about 15
seconds. Please be patient.
9.
When the main menu appears in the
display, the StimaWELL
Unit is ready for operation.
10.
As necessary, insert your admin card in the card slot. If
Therapy Only With Card
erwise operate the StimaWELL
(please see also Section 13 „Chip Cards").
4
Preparations For Stimulation
1.
Place the StimaWELL
an adjustable head piece. If required you can use a StimaWELL
2.
If you want to use mat heating it is better to switch on the heating approx. 10-20 minutes
before the patient's appointment time so that the StimaWELL
cient time to heat up.
3.
Place a paper roll on the StimaWELL
the mat electrodes.
4.
Using the spray can, evenly moisten the overlay. All electrode surfaces must be well mois-
tened. Please use tepid water so that the StimaWELL
water.
®
120MTRS Control Unit with
®
120MTRS Control
has been set you cannot oth-
®
120MTRS Control Unit
®
Stimulation Mat on a soft couch (e.g. a patient's couch) ideally with
®
Stimulation Mat, ensuring that the paper covers all
®
Mat underlay.
®
Stimulation Mat has suffi-
®
Stimulation Mat is not chilled by the
EN
- Quick Links:
- Purpose of Use
Hide quick links:
Advertisement
Table of Contents
