Set-Up And First Time Starting - schwa-medico StimaWELL 120MTRS Operating Manual

OPERATING MANUAL STIMAWELL® 120MTRS
3

Set-Up And First Time Starting

The following describes the set-up and first time starting for the
®
StimaWELL 120MTRS System:
1. Place the control unit on a smooth, even surface. Please ensure that the ventilation slits
are not covered.
2. Please ensure that the StimaWELL
positioned directly adjacent to each other nor stacked; this to avoid mutual interference.
Should this not be possible, the function of the respective devices must be monitored to
ensure proper function.
3. Connection For The Supply Voltage
The connection for the mains power cable is located
on the rear side of the StimaWELL
Unit. It should be checked that the available mains
power voltage and frequency values comply with the
data on the rating plate. The control unit is then to be
connected to the mains cable and the plug plugged
into the mains electricity socket.
4. Connecting The Remote Control Unit
Connect the remote control via the connection provided
on the rear side of the StimaWELL
Unit. When disconnecting the remote control from the
socket always grip the plug housing. Never pull on the
cable. Please note here the white marking on the plug
and on the socket.
5. Place the StimaWELL
®
maWELL 120MTRS Control Unit in the required position.
Whenever changing the position relative to each other,
first remove the plug for the StimaWELL
Mat. Do not allow the StimaWELL
when positioning to avoid damaging the connecting ca-
ble and the plug.
6. Connecting The StimaWELL
Connect the StimaWELL
connection socket on the rear side of the Sti-
®
maWELL 120MTRS Control Unit. Please ensure here
the correct alignment. When disconnecting the Sti-
®
maWELL Stimulation Mat from the socket always grip
the plug housing. Never tug/pull on the cable.
®
120MTRS System and other electrical devices are not
®
120MTRS Control
®
120MTRS Control
®
Stimulation Mat and the Sti-
®
Stimulation Mat to fall
®
Stimulation Mat
®
Stimulation Mat via the
®
Stimulation
EN 13